Key Facts

 Product features

  • Fast curing, maximum leak protection
  • Excellent gap- filling properties
  • Easy bonding even on large surfaces
  • Resistant to bacteria
  • Medium pressure (6 bars)
  • Yellow color as indicator
  • No primer needed

Possible uses

Pattex PVC Medium Pressure is used for joints resistant to tensile strain of medium pressure fittings and pipes up to 15” diameter. Can also be used for gluing cable conduits, drain pipes etc.

Content:

  • Can 500g

Storage:

This product should be stored in its original packaging in a cool, dry place, protected from frost, sparks, and flames. Close packaging after use.

Keep away from children.

Shelf life: 15 months from manufacturing date.

Key Notes:

  • Make sure to read the application and safety instructions given in our Technical Data Sheet and Safety Data Sheet.

Application

Surface preparation:

Surfaces should be leveled, dry, clean of dust and free of substances which may impair adhesion. Cut pipe squarely, chamfer (15 degrees) and deburr. Insert pipe in fitting and mark depth. Clean both surface ends thoroughly. Stir Pattex well and apply an even layer of adhesive (thin layer on fitting, thicker on pipe) in an axial direction with a dauber. Assemble the parts within 4 minute (at 23°C) without turning, and hold firmly for a few seconds. Remove excess adhesive. Do not expose the bonded joint to mechanical stress at least 5 minutes (below 10°C 15 min).